//This is the base section
//This value controls the resolition/ face count
$fn = 50;

//Base
difference(){
translate([0,-2,-45]) cube([46, 34, 4], center = true);;
translate([-4,-2,-45]) cube([24, 20, 5], center = true);;
translate([7,-2,-45]) cylinder(h=5,r=10, center = true);;
}
//Side
difference(){
translate([-21,-2,-15]) cube([4, 34, 60], center = true);

rotate([-45,0,0]) translate([-21,0,14])  cube([5, 50, 30], center = true);

}

//Face
difference() { 
translate([0,0,0]) rotate([-45,0,0]) cube([46, 45, 6], center = true);;

//HR sensor hole
rotate([-45,0,0]) translate([0,0,-5]) cylinder(h=10,r=8);

//Watch body cutout
rotate([-45,0,0]) translate([0,0,-1]) cylinder(h=10,r=25);

//Bandcutout
rotate([-45,0,0]) translate([0,0,2]) cube([38, 55, 6], center = true);;

//Power cord cutout
rotate([-45,0,0]) translate([17,0,0]) cube([13, 13, 10], center = true);;

}

//Pegs
rotate([-45,0,0]) translate([21,20.5,0]) cylinder(h=8,r=2);
rotate([-45,0,0]) translate([-21,20.5,0]) cylinder(h=8,r=2);
rotate([-45,0,0]) translate([21,-20.5,0]) cylinder(h=8,r=2);
rotate([-45,0,0]) translate([-21,-20.5,0]) cylinder(h=8,r=2);